angle_line Start Checklist

Angle Line ID

Did the previous operator shutdown correctly?

Yes
No

Is there any damaged components/oil leaks on machine?

Yes
No

Have you checked if the machine needs lubricant?

Check all lubricated points as per user manual

Yes
No

Is there wear or damage to tooling, replace as needed?

replace tooling needed

Yes
No

Check proximity switches/sensors for damage , is there any damage?

Yes
No

Check hydraulic unit oil level in sight glass, is hydraulic oil low?

Yes
No

Have you checked water separator on pneumatic line, drain if needed. Also note level of oil in oiler, fill if needed ?

Yes
No

Have you checked that punches/dies and shear blades are tight ?

Yes
No

Have you checked entry and exit measuring wheels and signomat?

Yes
No

Do the punches and dies in raptor correspond to the punches and dies in the machine?

Yes
No

Do you have material?

Ensure material to be ran is present, programs are ready and prints are available to verify calibrations. Check first part of day, then every third part. Note any deviation to supervisor

Yes
No

Comments

Who is completing the checklist?