Xdm Start Checklist

Xdm ID

Did the previous operator shutdown correctly?

Yes
No

Is power on?

Check that plug is in and power turned on

Yes
No

Have you checked around machine, note any damaged components/oil leaks?

Note damages in comments section

Yes
No

Have you cleaned the cameras?

Clean 3xcameras

Yes
No

Have you Inspected tooling ?

Inspect tooling for wear or damage, replace as needed.

Yes
No

Is the x reference laser clean ?

Clean x reference laser on bottom of w and z axis spindles

Yes
No

Have you checked hydraulic unit oil level in sight glass?

Check hydraulic oil and top up if needed

Yes
No

Have you checked oil and water seperator?

Check water separator on pneumatic frl on back of machine, drain if needed. Also note level of oil in oiler, fill if needed

Yes
No

Is there any damage to machine?

Inspect saw for any damage, open guards to inspect blade cleaning brushes. Adjust/ replace if needed

Yes
No

Have you checked toolchanger params?

Check toolchanger params and verify tool positions in params match tools in spindle if any present.

Yes
No

Do you have material?

Ensure material to be ran is present, programs are ready and prints are available to verify calibrations. Check first part of day, then every third part. Note any deviation to supervisor

Yes
No

Comments

Who is completing the checklist?